[. . . ] The France subscription is a lifetime subscription; it does not expire. The GTM 11 includes an FM TMC traffic subscription to a pay service; however, the subscription varies, depending on your location. Check the Garmin Web site at http://www. garmin. com/fmtraffic for other available services. In addition to pay services, the GTM 11 can always use any free services available. Service Information European Packages US Packages The European GTM 11 uses the free services available in many countries in Europe. [. . . ] To remove the antenna from the GTM 11, press the antenna connector's tab. Pull the antenna off the GTM 11. 2 GTM 11 Owner's Manual TESTING AND MOUNTING THE GTM 11 TESTING THE GTM 11 Use the following testing and troubleshooting techniques: Observe the LED on the GTM 11: Service reception is indicated by the green solid light, which can take up to five minutes to appear for initial data acquisition. Yellow dot-dash flashes: determining which country you are currently in. Yellow solid light: searching table for active entry or scanning for new TMC FM stations Red solid light: momentary sync loss. Verify Signal Strength: The traffic information list on the GPS device shows a signal strength indicator in the upper-right corner. Refer to the owner's manual to learn how to access the information list. Verify that you are in a service area: Check for service from the pay service or free services, if available. To view service areas, go to the Garmin Web site at http://www. garmin. com/fmtraffic. Verify that the paid subscription is activated: If the GTM 11 is using a pay service, verify that the subscription has been activated in the Garmin GPS device. Refer to the GPS device's owner's manual to learn how to add subscriptions to the GPS device. GTM 11 Owner's Manual MOUNTING THE GTM 11 After you have connected and tested the GTM 11, you can mount it using the hook-and-loop fastener or the permanent adhesive. For best signal reception, mount the GTM 11 on the A-pillar, which is the area between the windscreen and the door. Clean and dry a section of the A-pillar or other suitable mounting surface. Firmly press the adhesive on the back of the GTM 11. Attach the adhesive here. 3. Firmly press the GTM 11 to the mounting surface. NOTE: When mounted, the adhesive is extremely difficult to remove. 3 TESTING AND MOUNTING THE GTM 11 To mount the GTM 11 with the hook-and-loop fastener: 1. Clean and dry a section of the A-pillar or other suitable mounting surface. Firmly press the hook material to the back of the GTM 11. Attach the hook material here. Routing the Cable Route the GTM 11 cable so that it does not interfere with vehicle operating controls. If the cable is not long enough, a 2-meter extension cable is available from your Garmin dealer or at http://www. garmin . com/products/gtm11. Notes about the Hook-and-Loop If you use the hook-and-loop fastener to attach your GTM 11 to the A-pillar, you can also install a strip of loop material on the A-pillar of another vehicle. [. . . ] To avoid the traffic incident, touch , touch an incident in the list, and then touch Avoid or Detour Around. Viewing Traffic Information Each GPS device lists the traffic incidents that are near your current location. Touch an item to view details. GTM 11 Owner's Manual Severity code Traffic symbol Signal strength Changing the Traffic Settings Some Garmin GPS devices allow you to change the Traffic Settings. For example, from the Menu page, touch Settings > Traffic. NOTE: Not all Garmin devices allow you to change the Traffic settings. 5 Traffic Service End User Subscriber Agreement The Traffic Service Provider holds the rights to the traffic incident data and RDS/TMC network through which it is delivered. [. . . ]